|
||||
Did you do a hard reset before and after the 3.3 install?
![]()
__________________
“It is from numberless diverse acts of courage and belief that human history is shaped. Each time a man stands up for an ideal, or acts to improve the lot of others, or strikes out against injustice, he sends forth a tiny ripple of hope.”
Robert Kennedy Ha y'all come visit me at WMExperts some time. ![]() |
|
||||
sync via activesync before you do the rom upgrade to 3.3
then flash then resync via activesync. once you make the jump to 3.3+ you will be able to sync with exchange going forward. Under no circumstances should you use the pim.vol from a aku build of 2.2 or lower. follow our advice and it will be smooth sailing on your contacts.
__________________
Big Red - Winblows 6.WTFCares....TP2 does Droid!!!
|
|
||||
I am having the same exact problem and I have tried several different 3.3 and 3.5 roms all with the same result..
I think it might be because Im allowing all the verizon roms to load after a hard reset. Here is what I do.. Sync phone to make sure its all backed up. Put phone in bootloader mode run the rom installer reset the phone after screen calibration I have been letting all the verizon roms install themselves. Contacts wont open, just flashes and when I try to use active sync it wont sync my contacts and gives a not enough memory error. I have the latest verizon rom and have flashed back to it at this point and all is working just fine.. Any one got any ideas? thanks Phil |
|
||||
I had the exact same problem. But its because you didnt hard reset press the two - buttons and hold. Then take your sylus on press the soft reset buttonon the bottom of the device. Press Y to clear. It will reboot and bring you back to setup. You will now find you contacts much more responsive. I promise
![]() |
![]() |
|
|
|