Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

I tried this still no good, so I got it to get to the tricolor screen by putting the manual.exe file and then pressing the vol.down and soft reset and holding the power button. once it got there, it just hung at 0% and it gave me a 262 connection error that it couldn't communicate with the device.
do you think I have a defective device? eventhough I was able to sync with activesync.

I was told in another forum to put the .nbh file in the sd card and then it should work.

any suggestions/ideas?

Thanks in advance.

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

Sounds like u got bad drivers plug the phone in and check device manager for questions marks or red x's also insure u r not using a usb hub. The likelyhood of your device being defective is rare based on what u said.

Also u can not flash new bootloader from entering using the method u stated I would go reread post one very thoroughly.

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

Ok, I will check my drivers, but this happened in 2 different computers. one with vista and one with xp. if it was a bad driver wouldn't it give me the same problem when I sync with activesync?

I will check device drivers when I get back.
Thanks.

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

Off topic.....Nex you working on a rom for the TP?:mrgreen:

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

Maybe if I didn't brick my TP. So until I get a replacement not yet.

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

How did you order your replacement? asurion? Just curious as I have one on the way

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

Haven't gotten one yet but I plan on taking it to bestbuy and making them swap it since its under 30 days..

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

I checked device driver, everything is fine there. when I am in tricolor screen it says security unlocked.
raph800
spl-0.37.000
MicroP-Hermann

and then it just hangs at 0% and gives me connection error 262 or update error.

I don't know what else to do so if anyone has any suggestions, I am all ears.

Thanks.

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

Once again u really need to reread the first post u CANNOT FLASH A NEW BOOTLOADER FROM THE BOOTLOADER SCREEN U ARE ENTERING NOWHERE DOES IT SAY TO ENTER BOOTLOADER BY ENTERING THE KEY COMBINATION. I would say try being all eyes instead of all ears and read the post.

Re: Touch Pro CDMA Hard-SPL brought to you by CDMA Raphael Elite Team
 

Sorry, just thought this was funny!