Diamond_C CDMA SSPL and HardSPL package is here now!

[Antrax]

Thanks man!!!!!!

[itr325]

Originally Posted by tobeychris

OMFG What did you do.

There is no CDMA radio to flash... just be lucky your phone turns on.

Oh, and if it still works properly, don't try that again.

I tried the same thing, still displays the original radio. Is there not a upgraded radio for CDMA yet, or does CDMA not have a radio?

[cornelious2]

the diamond came out less than a month ago for sprint... how in the heck do you expect them to have a radio update already.

[tobeychris]

Originally Posted by itr325

does CDMA not have a radio?

Really?

[nodiaque]

Hmmm... if I understand well from xda, this app is used to prevent bad rom-flashing thus bricking phone, right? So before flashing, I should install this and then I can install juicy roms and others, right?

Thanks

[tobeychris]

Your understanding is completely wrong.

Without this, you CANNOT flash any other ROM. Well, unless you make your own spl.

[nodiaque]

Ah ok, might be good to say that in the "how to flash with roms (http://forum.ppcgeeks.com/showthread.php?t=36062)" because reading this, it's not needed

[puff]

you cannot install a custom ROM without first unlocking. depending on the SPL it can be either SoftSPL (no overwrite protection) or HardSPL (overwrite protection) - of course the HardSPL will serve two purposes... 1) allow you to install custom roms and 2) prevent SPL overwrite in case of flashing shipped (exe) ROM. Anyway until there's an actual ROM update (exe), its pretty useless to have overwrite protection as there are no ROMs in development that actually even attempt to write radio and/or bootloader. Thus this pretty much eliminates purpose #2 - well at least for the time being...

[gnafin]

i want to return my diamond for a new one, how do i go back to the stock SPL ?

[puff]

Originally Posted by gnafin

i want to return my diamond for a new one, how do i go back to the stock SPL ?

run the relocker found here