Guide to get Nand working on TP2

[arrrghhh]

Originally Posted by eurohunter

I can't seem to install the fastboot driver. when i test adb, it's fine, it shows 000000 under devices, but when i type "fastboot devices", nothing shows up. So I shut down my phone and pressed Volume Down and Power to get into that three-color screen. Then connected phone with usb to my laptop (at the bottom of the screen it reads "serial", not 'usb'). I tried to update the wrongly-installed driver in Device Manager ("qualcomm cdma something") and i directed it to the 'PdaNet for Android', but I just get a pop up that says it could not locate the driver. What am i doing wrong??

Well first of all you went back to the tri-color screen, which is WinMo bootloader, to update a driver for fastboot/Android?

Try updating the driver in fastboot mode.

Originally Posted by Dinomon1

What is the difference between the NAND vs regular GBX0B release? GBX0B is put on the SD card, how about NAND?

By process of elimination if this isn't installed on the SD card, what is it installed on?

NAND. It's kind of a misnomer, since technically most flash cards also use NAND flash memory, it stuck for whatever reason. So it's installed over WinMo. Still in testing, not for the feint of heart, blah blah blah.