Re: [TESTING] - NAND OMGB (1.2.3)
 

OK, I try it again.
wipe data and cache in recovery.
I even used OMGB_rhodium-1.2.3-12052011.zip without new libhtcgeneric-ril.so.
After reboot, I can still get service.:mrgreen:

It means build.prop change is not required, but I think somebody can try it.

Re: [TESTING] - NAND OMGB (1.2.3)
 

this is completely OT but i'm screwed with the infamous white screen of death.

Went back to sprint rom and once i reboot its back to the same crap. Its as if the boot loader will only boot after a fresh flash then wont boot at all. Yes i did task 29 and all that poop. Anyone know of a successful way to get this working?

Re: [TESTING] - NAND OMGB (1.2.3)
 

ACL - Another log (last_kmsg).

The phone was charging but not being used. Went to check it and it was unresponsive. Plugged it in to my computer and tried to pull logs but adb just hung with a message "waiting for device".

I hit the reset button and pulled this log. I see a null pointer deref near the end along with a stack dump, but that's about as far as I get with understanding.

Hopefully this contains some useful crash information.

Re: [TESTING] - NAND OMGB (1.2.3)
 

this is an old bug. I'm adding it to the issues list on the project page. Thanks a bunch.

Re: [TESTING] - NAND OMGB (1.2.3)
 

No problem.

I have to admit I find it funny that you are thanking me, but I'll take it. :mrgreen:

Re: [TESTING] - NAND OMGB (1.2.3)
 

Hi ACL
Could you check the newest logs of rhod100 calling mic issue in #727?
The setup is from yours.

http://forum.ppcgeeks.com/2160376-post727.html
There are 3+ times call and 3 version logs, I also tested the LS. Hope it's useful to do troubleshooting.

BTW:

I heard on solution for no GSM service of rhod100, maybe you guys can try if no service:

You can dial 112, wait a minute after hanging up, the service shows.

Re: [TESTING] - NAND OMGB (1.2.3)
 

I do as you say. And i heard emergency service voice. Then i try to hang up but is don't hang up. Then i remove battery.
Starting again. No signal, then i try to call by 111 (is our service) network not aviable show me, then i try to check my money *1011*10# but still no luck. Then i try again call to 112 and is show me out of service.
BUT then i have signal and edge symbol showing.
I'm writing just now so i haven't test calls yet.

Re: [TESTING] - NAND OMGB (1.2.3)
 

Now i make one call to operator service by number 111. I don't check the microphone but i will do this in next step. Here is my logs

Re: [TESTING] - NAND OMGB (1.2.3)
 

Now i have incoming call i hear voice but don't hear my.GPRS working but arrows that shows in/out data don't show this. Here is logs

Re: [TESTING] - NAND OMGB (1.2.3)
 

Heard a rumor of flashing stock SPL back and then HardSPL again + task 29 to resolve. No idea if it works as it's never happened to me.

Michael