02-09-2010, 07:44 PM
|
||||
|
||||
|
bootscreen/rom help
new to flashing roms so bear with me...
my tp is crap, upon startup it loads straight to the red/green/blue "bootscreen" it reads: ------------------------------------- Security Unlocked RAPH800 SPL-0.37.0000 MicroP-Hermann (LED) v0C85 MicroP-Hermann (KEY) v0C85 PSOC-Raph STAGE_EVT v20 Serial ------------------------------------ since i cannot get past this screen is it even possible to flash a new rom? i dont know what the problem is and this brick isnt doing me any good like this... any help/suggestions would be appreciated! 
|
|
02-09-2010, 08:12 PM
|
||||
|
||||
|
Re: bootscreen/rom help
not a problem. plug the usb cable into it and you'll see it change from serial to usb. you can flash from there without issue.
|
| This post has been thanked 1 times. |
|
02-09-2010, 08:18 PM
|
||||
|
||||
|
Re: bootscreen/rom help
when i plug the usb cable in, the "Serial" goes away but it doesnt change to usb and my computer doesnt recognize that its there??
|
|
02-09-2010, 08:36 PM
|
||||
|
||||
|
Re: bootscreen/rom help
try to run a rom anyways. my computer never says it's there but it always connects and runs without issue. it does usually say usb from what i've seen but i dunno.
also you can try putting the raphimg.nbh from your rom on an sd card and run it from there too.
|
 |
|
«
Previous Thread
|
Next Thread
»
Linear Mode
|
|
All times are GMT -4. The time now is 12:02 AM.
