|
||||
Re: help:backlight setting fails to perform
I've run into this before, and haven't figured out exactly what triggers this, but this is how to fix it:
HKCU\Control Panel\Backlight\LockLevel\LockLevel - the dWord there should be 0. I've found it set to 1 or 2, for no apparent reason.
__________________
|
This post has been thanked 2 times. |
|
||||
Re: help:backlight setting fails to perform
Quote:
thanks a lot! it really works! love you!!! |
|
||||
Re: help:backlight setting fails to perform
Thanked you! My D word was 1, setting always defaulted back to 10 sec which wasn't quite enough sometimes. Now have it at 30 sec which I like.
|
|
||||
Re: help:backlight setting fails to perform
Glad this worked for you all.
I haven't determined precisely what triggers this behavior, but at times, it seems to occur if I have the TP2 plugged into a power source, and reset it. For example, I have SPB Backup run every night at 10:00 pm, and if it's plugged in to power, it does its thing, it soft resets when it's done, and at least some of the time this Registry key gets changed. So I suspect it's something along these lines, but really haven't conclusively researched it. |
|
|
|