My vibrate mode wont work anymore!
Help! I dled a couple of the regedit cabs and now my vibrate feature wont work anymore! Can someone help me to get it back plz? I have the reg editor now so I can access all the tweaks now. Does anyone kno the code to gettin the vibrator back on???
|
which reg edit cabs did u dl?
|
well I actually played with a few of the instructing ones too. such as the bt ones, the ones to make it faster, basically all of the ones in http://forum.ppcgeeks.com/showthread.php?t=5108
|
Quote:
15-Change Vibrate Strength HKLM\SOFTWARE\OEM\VIB STRENGTH_LOW set to 1. and 18-Change ringtone/vibrate/LED flash characteristics If you would like more control over how your device rings/vibrates/flashes its LEDs on events, you can can change the Script values of these events. For example, for an incoming call performing 'activate device, play ringtone, wait 3 seconds, repeat': HKCU\ControlPanel\Sounds\RingTone0\Script = "apw3r" (REG_SZ string, no quotes) For performing 'active device, set volume to 33%, play ringtone, set volume to 67%, play ringtone, set volume to 100%, play ringtone (no repeat)': HKCU\ControlPanel\Sounds\RingTone0\Script = "ac33pc67pc100p" (REG_SZ string, no quotes) The following are the full codes available to you. Please note that all the codes are executed simultaneously except after a ringtone play / wait code. E.g. 'v1p' will vibrate and play at the same time, while vibrating for 1 second. But 'pv1' will play the ringtone through all the way first, then start vibrating for 1 second. a = activate device cN = set volume to N in percentage max volume fN = flash notification LED for N seconds p = play ringtone. Note that this will play the ringtone all the way through before continuing with the next code. r = repeat. Note that this should be the last code in your Script string, if used at all. vN = vibrate for N seconds wN = wait for N seconds. Note that the device will wait this long before continuing with the next code. NOTE: I tried this on my 6800 and changed the v0 to v1 and now it doesn't have just one long vibrate. v0 sets it to vibrate always. if u did these just do the opposite...otherwise my only advice is hard reset. |
nope, all those settings are fine. Is there a specific folder for the vibrator that I can chinese blueprint off of? Im screwed arent I?
|
Quote:
|
damn I hate hard resetting it!!! Thanx anyway bro.
|
Quote:
http://forum.ppcgeeks.com/showthread.php?t=14349 and check ur pm's |
whats the default vibrate strength?
|
Quote:
im pretty sure...did u check ur pm's? |
All times are GMT -4. The time now is 03:27 AM. |
Powered by vBulletin® ©2000 - 2024, Jelsoft Enterprises Ltd.
©2012 - PPCGeeks.com