My vibrate mode wont work anymore!
 

Help! I dled a couple of the regedit cabs and now my vibrate feature wont work anymore! Can someone help me to get it back plz? I have the reg editor now so I can access all the tweaks now. Does anyone kno the code to gettin the vibrator back on???

which reg edit cabs did u dl?

well I actually played with a few of the instructing ones too. such as the bt ones, the ones to make it faster, basically all of the ones in http://forum.ppcgeeks.com/showthread.php?t=5108

none of them shouldf affect ur vibrate except

15-Change Vibrate Strength

HKLM\SOFTWARE\OEM\VIB

STRENGTH_LOW set to 1.

and

18-Change ringtone/vibrate/LED flash characteristics

If you would like more control over how your device rings/vibrates/flashes its LEDs on events, you can can change the Script values of these events. For example, for an incoming call performing 'activate device, play ringtone, wait 3 seconds, repeat':

HKCU\ControlPanel\Sounds\RingTone0\Script = "apw3r" (REG_SZ string, no quotes)

For performing 'active device, set volume to 33%, play ringtone, set volume to 67%, play ringtone, set volume to 100%, play ringtone (no repeat)':

HKCU\ControlPanel\Sounds\RingTone0\Script = "ac33pc67pc100p" (REG_SZ string, no quotes)

The following are the full codes available to you. Please note that all the codes are executed simultaneously except after a ringtone play / wait code. E.g. 'v1p' will vibrate and play at the same time, while vibrating for 1 second. But 'pv1' will play the ringtone through all the way first, then start vibrating for 1 second.

a = activate device
cN = set volume to N in percentage max volume
fN = flash notification LED for N seconds
p = play ringtone. Note that this will play the ringtone all the way through before continuing with the next code.
r = repeat. Note that this should be the last code in your Script string, if used at all.
vN = vibrate for N seconds
wN = wait for N seconds. Note that the device will wait this long before continuing with the next code.

NOTE: I tried this on my 6800 and changed the v0 to v1 and now it doesn't have just one long vibrate. v0 sets it to vibrate always.

if u did these just do the opposite...otherwise my only advice is hard reset.

nope, all those settings are fine. Is there a specific folder for the vibrator that I can chinese blueprint off of? Im screwed arent I?

huh there is no folder that has to do with vibrate...i think its hard reset time,sorry..

damn I hate hard resetting it!!! Thanx anyway bro.

yup sorry i couldnt be much help...but check out my thread on monocube safemode...ull never have to hard reset again!!

http://forum.ppcgeeks.com/showthread.php?t=14349

and check ur pm's

whats the default vibrate strength?

strength_low = 0
im pretty sure...did u check ur pm's?

thanx bro, not yet I havent checked em BUT I did find out what CAUSED the vibrate to go off... for everyone:
I shut off my blinking LED!!! Dont do this code unless you dont mind your vib off!!!

Hkey_Local_Machine/Drivers/Builtin/AllLEDMgr
And change the Index value from 1 to 0
Then soft reset.

This is for both the blue and green LEDs.

[EDIT. Note: This deactivated the vibrate mode on my phone]

If someone could tell me the index of this code, I think I can fix it. I just need the 3 codes for index n 3 codes for order plz.