|
||||
|
Re: stylus shape and size?
The ones for the Centro definitely will not. They are too short and a little too thin and will disappear inside the 800.
__________________
![]() |
| This post has been thanked 1 times. |
|
||||
|
Re: stylus shape and size?
Quote:
Worst stylus I've ever had on a PPC (even worse than the HP Jornada's flat one). It's lightweight and plastic (both OK, IMO). BUT, far too flexible and bends a lot when you use it. |
|
||||
|
Re: stylus shape and size?
Actually, I have gotten used to it. At least it doesn't fall out of the phone like the 6700 did (I always had to 'crimp' mine with pliers to get it to stay). Sure its flimsy but it works.
I installed touchflo and that helps quite a bit (scrolling and such). |
|
||||
|
Re: stylus shape and size?
Quote:
A couple of questions re Touchflo: - Which one are you using? - Is it faster? i.e. does it appear to use HW acceleration? - Doesn't the recessed screen make it a bit difficult to use? TIA |
|
||||
|
Re: stylus shape and size?
Quote:
- As compared to?? I was running it on a PPC6700, seems snappier but then again so does the entire device - Depends... my 6700 had a recessed screen, so perhaps I am just used to it. Doesn't seem to affect what I am trying to do with it I also use WKTask which gives me good 'thumb' access to most of my programs as well as the today screen. |
|
||||
|
Re: stylus shape and size?
Found this over in TreoCentral from Seidio:
Seidio Pen Stylus for Treo 800w Pre-order Now. Shipping begins on Aug 8, 2008. Seidio's Pen Stylus is a high quality stylus and writing pen in one. It is a higher quality alternative to the original plastic version. - Made of metal for increased rigidity and longevity - Engineered specifically for your device - Quality stylus tip - Built-in ballpoint pen http://www.seidioonline.com/ProductD...;2DSY3IN1TR800 They also have a metal stylus replacement : http://www.seidioonline.com/ProductD...ctCode=SYTR800 (I know I am getting them as soon as I get the 800w!!!!) Last edited by syrguy1969; 08-04-2008 at 05:18 PM. |
| This post has been thanked 1 times. |
![]() |
|
|
|