|
|
||||
Re: Anyone notice this?
Quote:
![]() What pisses me off though, is that if the battery is too low to run the phone...it always seems to have power, for like 6 or more boots, to do the whole lengthy boot process and then turns off right when the phone would start becoming useful |
|
||||
Re: Anyone notice this?
It's hair ripping, I'm a person that likes to completely kill the battery before I charge it (I'm very anal about it). So I have to sit and do those stupid cycles.
|
|
||||
Re: Anyone notice this?
Quote:
You are used to dealing with NiCad batteries that should be FULLY discharged and recharged. Our phones use LiPoly batteries. Not only is it not necessary to completely discharge them, but you will actually damage the battery by doing so. LiPoly batteries must be kept at a VERY specific voltage range. Over or under charged, will damage it. Your phone knows when to stop the charge AND when to stop the drain. |
|
||||
Re: Anyone notice this?
There are 3 "tracks" that the KB uses when opening and closing. The center one aligns with the bottom barrier of "Call History" when the phone is closed. All that is needed to demonstrate this is to open your keyboard as normal, and remember the physical location of the "track" in relationship to the screen in portrait mode.
No, I do not open my keyboard when there is no reasonable need to do so. To do otherwise places unnecessary load on the keyboard retraction/extension assembly. (you're wearing out your phone for no purpose if you extend and retract the keyboard when you otherwise do not need the functionality of the keyboard). This would not be the cause, (in an otherwise not defective unit), anyhow. It's just a bi-directional cam that requires 2oz of pressure to move in either direction, and assistance is rendered when it reaches 45% of either direction of movement). If you are witnessing the cam pressing against the rear of the LCD assembly, you have a defective phone from either abuse, or the manufacturer.
__________________
Phone: Samsung Infuse ROM: ★ GSInfuse 1.1.5 ★ Firmware:: 2.3.5 Baseband: UCKJ3 Kernel: 2.6.35.7 - I997RUXG3-CL366622 user@netbook #Infusion-GB-CoreA Last edited by k_semler; 09-09-2009 at 01:07 AM. |
![]() |
|
|
|