Touch PRO ##DEBUG# & RADIO questions
 

Is there like a wiki or something on ##debug# on what everything means? I'm off of work and looking to test out every radio to see what gives me best results.

Also I have a sprint TP on Sprint, would i be able to flash any radio ie: USCC, Verizon etc... or do i need to stick to the sprint ones?

Re: Touch PRO ##DEBUG# & RADIO questions
 

I don't know the answer to the first half of your question, but for the 2nd half you can flash any radio that you want. The one that most people find the best and myself included is the sprint radio v 1.11. us cellular came out with one yesterday but i haven't tried that one yet.

Re: Touch PRO ##DEBUG# & RADIO questions
 

im currently on the sprint 1.11 and i only get like 2 bars everywhere and it drops signal all the time and my DATA speeds are 400kbs with EVDO speed tweak haha. i live in milwaukee, wi a pretty populated busy city too):

Re: Touch PRO ##DEBUG# & RADIO questions
 

You mean ##778#?

Re: Touch PRO ##DEBUG# & RADIO questions
 

why haven't you changed back then, just wondering?

Re: Touch PRO ##DEBUG# & RADIO questions
 

hmm.. it asked me for a password... (##debug#)

Re: Touch PRO ##DEBUG# & RADIO questions
 

With ##DEBUG#, heres what you need to know for the sake of testing radios.

In the 1x view, which is what it defaults to...:

RX Power: power level in dbm received from the tower. The levels are displayed as negative (-) numbers, and levels closer to 0 are better.

RX Ec/Io : signal to noise level, displayed in db.. lower numbers are better again.

Those are the two important ones.

Going to debug info on the bottom, and switching to HDR. HDR is aka EVDO (data only)...:

RX Power: same deal as above.

RX Signal Strength : Similar to ec/io above, but is the inverse... higher numbers are better (stronger and more clean signal).

Active Set Pilot : The current evdo pilot youre connected to. Each tower has 3-4 pilots... usually corresponding to what side of the tower you're feeding from. You should see one number in this blank only. If you see two, your phone is suffering pilot pollution, and you'll see degraded speeds.

Requested Data Rate: the negotiated rate between your handset and the tower. This is not necessarily the speeds you will see, as you're limited by the tower's backhaul, however this displays the maximum rate than can take place between you and the tower. Highest rate, coupled with highest RX Signal Strength, the better faster and more reliable data session.

I'll provide more detailed information if its needed, however, this is the basics you'd need to know to get the best service possible. :D

You're welcome. :)

Re: Touch PRO ##DEBUG# & RADIO questions
 

don't mean to hijack this thread, but is it supposed to ask you for a password when you ##debug#?

Re: Touch PRO ##DEBUG# & RADIO questions
 

it didn't ask for my password so i dont think so

Re: Touch PRO ##DEBUG# & RADIO questions
 

Nope. Your MSL isnt required to go into fieldtrial mode, as there are no settings to change, only things to view.