![]() |
Re: FM Radio Discussion
yea i have a diamond an the pro both for sprint an the radio is just perfect on the diamond, dont be surprised when these part 2's come around they might be missing moreee then you think....with the economy :headbang::headbang::headbang::headbang::protest:
|
Re: FM Radio Discussion
Quote:
|
Re: FM Radio Discussion
Quote:
|
Re: FM Radio Discussion
like En Vogue said back in the day.. "Never gonna get it, never gonna get it, never gonna get it" LOL
|
Re: FM Radio Discussion
Quote:
|
Re: FM Radio Discussion
Quote:
-s |
Re: FM Radio Discussion
Quote:
|
Re: FM Radio Discussion
anyone still looking into this?
|
Re: FM Radio Discussion
cant be done
|
Re: FM Radio Discussion
Ok guys. I have once again gained enough steam to, yet again, dig into my Sprint Touch Pro.
BTW: I do know this is old news, but some of us are too poor to get the TP2 yet. Until I get the funds to get a TP2, I'll keep cracking away at the TP. After replacing the drivers with the old versions (from this site) I installed the cab file for the radio (also, on this site). What did I get... nada. Except, it was operating the HW. I know, I know. Old news. Before flaming, please hear me out. With the above in mind, I cracked it open and put a conductive paste across each "missing" passive joint. For example, If a resistor was suppose to be here in the "radio enabled" version, and removed on the current version, the paste will create a loose connection that should enable the radio. Once again, I did this across ALL missing components without discrimination. My results? Well I was able to tune to three local stations (read stations less than a quarter mile away), but still no audio. I did put the output of the phone into a very large amp and heard something promising. I heard the internal amp engage for about ten seconds whenever I tuned, muted, or changed volume. When it was engaged I could just barely make out music and voices. As a reminder, that was through a very large amp! Well folks, I have stretched my little Touch Pro just about as far as I dare. If anyone has any suggestions, questions, or comments; I'll be glad to hear them! Daniel |
All times are GMT -4. The time now is 10:21 PM. |
Powered by vBulletin® ©2000 - 2025, Jelsoft Enterprises Ltd.
©2012 - PPCGeeks.com