Zagg Invisible Shield...sucks?
 

I ordered this front/back "shield" for my TP2 before I even had the phone. I picked up the phone last night and applied it exactly as instructed. Now it looks like ***. There are alot of air bubbles that I can't get out. Has anyone else had this problem? Do they all eventually work their way out in 2-3 days as the instructions claim?

Re: Zagg Invisible Shield...sucks?
 

they're supposed to air out within a day... if not, that means you did a poor job applying it. if done correctly, you won't have any air bubbles. it's kinda hard to put on in my opinion. they have zagg stations in malls if you want one of their employees to do it for you...

i personally don't like these protectors because they don't fit right for the tp/tp2... a couple weeks and the smaller pieces and corners start to peel because of the curvature of the device. maybe they changed the design tho? before they had these dumb flaps at each corner.

Re: Zagg Invisible Shield...sucks?
 

yes thats how its suppose to be, if you completely tried pushing them out, then your good because thats just wet spots from the applicant you use, which dries out like said within 2-3 days, if not try using a air dryer to dry it out, but dont hold it to long next to your screen.

Re: Zagg Invisible Shield...sucks?
 

Not bashing here, but with a big ole flat screen like the TP2, you shouldn't have any bubbles at all when done. Spray plenty of water, I mean solution, and you will be good to go. Honestly can't say if the bubbles will be gone in a few days, I haven't had any that bad!

Re: Zagg Invisible Shield...sucks?
 

ya, i probably applied too much solution. i'm sure there aren't any Zagg stations around these parts....i may try to find a hair dryer or some ****.
or i'll just pull them off and go without protection...wouldn't be the first time..hehe

Re: Zagg Invisible Shield...sucks?
 

I wish we could figure out if there is really a good one out there.I really want a full body but everyone has something against each of them.

Re: Zagg Invisible Shield...sucks?
 

After applying a screen protector and letting it sit for 2 hours, would it be beneficial and speedier to let your phone sit in rice for 12 hours to get out the wet spots underneith the protector faster? I have gone through many screen protectors so far with my TP2 because I can't stand the screen being anything but crystal clear.

Re: Zagg Invisible Shield...sucks?
 

i don't think u can put too much solution... i used bodyguardz before, which is basically the same thing but a lot cheaper... still has solution and the strong material that they say is from helicopter blades.

anyway, in the instructions, it says not to be shy with the solution and that u can never apply too much. i applied a lot and didnt have bubbles after a day. it helps with fitting it on easily because it glides of the screen easier when applying.

Re: Zagg Invisible Shield...sucks?
 

I love the Ghost Armor I have on mine. You can't even tell there is anything on the screen.

Re: Zagg Invisible Shield...sucks?
 

I just received mine in the mail. Hopefully mine goes on well... I have never tried Zagg before.