PPCGeeks - Bricked phone? I have MightyRom on my phone and it wont load past the TP2 screen

PPCGeeks (http://forum.ppcgeeks.com/index.php)

- HTC Touch Pro 2 (http://forum.ppcgeeks.com/forumdisplay.php?f=97)

- - Bricked phone? I have MightyRom on my phone and it wont load past the TP2 screen (http://forum.ppcgeeks.com/showthread.php?t=133062)

Re: Bricked phone? I have MightyRom on my phone and it wont load past the TP2 screen

I'm about try that now. I just have to get into bootloader, connect via usb then run the stock RUU right?

The restarting seemed to be getting worse but then I plugged it into the computer while it was restarting and it went through the whole boot up process without restarting. So far it's been fine but I'm about to reflash now.

Re: Bricked phone? I have MightyRom on my phone and it wont load past the TP2 screen

As a general note, if the phone powers on and displays the boot screen, and you can get into bootloader mode, it isn't bricked. If you can't get into bootloader mode, then your SOL and have an expensive paperweight.

Wirelessly posted (htc Pocket PC: Mozilla/4.0 (compatible; MSIE 6.0; Windows CE; IEMobile 8.12; MSIEMobile6.0) Sprint T7380)

Quote:

Originally Posted by mrstak

Yeah, just turn your device off and wait a few seconds. Then push and hold volume down and while holding volume down push and hold the power button until bootloader shows. Have the shipped rom from your carrier (the .exe) ready on your pc. Then connect your device with usb and it should change from serial to usb on the bottom of the screen and then start the exe on your pc to flash.