HELP! Flashing Rom cable out..

[benjimanute]

Alright guys, so just my luck i was flashing a update energy rom to my TP2 and the usb cable came loose on 90% *sigh* So after that, immediately took the battery out and now since the cable came out while i was flashing a new ROM it appears to be bricked, it wont sync with my computer or show any led light, and goes straight into the bootloader multi colour screen, is there anyway at all to try get out of this bad situation

thanks!

[boredandtattooed]

flash via SD

[darren.wlsn1]

Originally Posted by boredandtattooed

flash via SD

think he wants to get unstuck from where hes at which is 90% flashed. lol

[benjimanute]

well, the usb came loose, so i had to take the cable out and exit the flashing, now it wont go back into flashing the rom..

[fishingmedic]

Can you get into bootloader?

[darren.wlsn1]

Originally Posted by fishingmedic

Can you get into bootloader?

no matter what he can manually.

[benjimanute]

It will automatically go into the boot loader as soon as i power on and continue to stay in boot loader

[ooxteme]

so once in bootloader does it just sit there? did you try to run the rom updater again?

[benjimanute]

this is what i get when i turn it on, The multi colour screen and the text below states

Rhod500 23m ss-bc
SPL-1.00.01iNex
(microp (LED) 0x0A
Microp(KEY) 0x04
Turbo Gw/Turbo sw
tp Mfg data

501w530 788ROM6
791,21b1204 203
208,855 calibrated

WITHOUT USB IN to pc (serial)


when i plug in the usb to computer with phone says (usb) but nothing picks up the phone (active sync)

[benjimanute]

UPDATE::::

I managed to continue to flash the ROM without active sync connected, it finished the rom instillation, then i took the battery out for 15 seconds, when i whent to turn it back on again nothing, i also have been holding down power and volume down together and nothing, when i plug into pc nothing, when plugged into charger no led lights or anything.....