Mogul shows main batt low even is fully charged! - Page 2

MKyles · #11 (**permalink**) 03-15-2009, 01:34 PM

How long have you had your battery? After a year my OEM battery wasn't good anymore and wouldn't hold a charge. I took it to the repair center and they gave me a new one for free. Hope this helps

superpr · #12 (**permalink**) 03-15-2009, 09:49 PM

Well! I just discharge the battery and turn on unit. The problem persist.

Q. How do I downgrade this DCAAXAM-4350H? Scince this was change batt stops showing charge.

**drewcam888** · #13 (**permalink**) 03-16-2009, 08:56 AM

What are you asking?

demonlordoftheround · #14 (**permalink**) 03-16-2009, 11:58 AM

Maybe a hard reset is in order. Remember to back up your contacts, etc because the hard reset will wipe all personal information and applications from the device..

Quirk · #15 (**permalink**) 03-16-2009, 02:27 PM

My titan used to show 0% battery (and get pretty warm) if I installed no2chem's custom power driver. Any chance you have that installed?

**shaggylive** · #16 (**permalink**) 03-16-2009, 06:16 PM

Quote:

Originally Posted by Quirk

My titan used to show 0% battery (and get pretty warm) if I installed no2chem's custom power driver. Any chance you have that installed?

that reminds me, sometimes going into power (or n2chem's power&backlight ) control panel and toggle a setting, exit, reboot, will fix the problem.

Keir333 · #17 (**permalink**) 03-16-2009, 06:31 PM

No2Chem's 1% battery driver caused the same problem on my Titan after going to WinMo 6.1 The battery was fully charged, but it showed that it was low, and since the phone thought it was low, it went into power save mode and shut down the cellular radio, so I couldn't make any calls.

Do you have this program installed?

-Keir-

superpr · #18 (**permalink**) 03-17-2009, 01:54 AM

Yes, is possible. The rom I use was a modified version of No2Chem's.

What should I do to correct this issue?

Keir333 · #19 (**permalink**) 03-17-2009, 03:02 AM

Quote:

Originally Posted by superpr

Yes, is possible. The rom I use was a modified version of No2Chem's.

What should I do to correct this issue?

Not sure, I'm not using a No2Chem ROM, and I just don't use that program now on my Touch Pro.

Quote:

Originally Posted by shaggylive

that reminds me, sometimes going into power (or n2chem's power&backlight ) control panel and toggle a setting, exit, reboot, will fix the problem.

Maybe try what Shaggy said and go into No2Chem's power & backlight control panel and look to see if there's a setting in there that could be changed to fix your problem....just a thought.

Hope this helps.

-Keir-

superpr · #20 (**permalink**) 03-17-2009, 05:14 PM

Back Again! I try fix recomended by Shaggy and no success. Any suggestions?