|
||||
Re: HOW TO: Recover a Diamond that won't get past the boot screen! (Instructions)
i tried pressing the left button while holding the reset and dwn volume but nuthin happens any help plz
|
|
||||
Re: HOW TO: Recover a Diamond that won't get past the boot screen! (Instructions)
The arrow button is on the right side of the D-pad. Try that and let us know how it works.
__________________
How to recover your Diamond from a hang at the boot screen!
Audiovox Thera-Samsung i700-Verizon PPC 6600-Sprint 6700-Sprint Mogul-Sprint Touch-HTC Touch Diamond-HTC Hero-HTC SuperSonic (EVO) |
This post has been thanked 2 times. |
|
||||
Re: HOW TO: Recover a Diamond that won't get past the boot screen! (Instructions)
I finally got this to work after a few tries. Something I didn't realize till I read the last post (cause I am the biggest diamond noob of all) is that the --> reference means
Quote:
|
|
||||
Re: HOW TO: Recover a Diamond that won't get past the boot screen! (Instructions)
Just an FYI since I didn't see it mentioned here. (You may want to add it to your op)
You don't need a stylus to enter bootloader or hard-resets. Here's some basic directions from a much longer post I did. The key is, the phone needs to be powered down, not just the screen. These are some of the ways to power down your phone. 1) If you have psShutXP installed, you can select "Shut Down", or 2) Push and hold the power button. You will be warned that you're shutting down the phone, or 3) Remove the battery. Once you're phone is powered down, decide which mode you want to go into. Make sure the "PowerButton" is the last button you push and hold, since that will turn your phone on. Note: Push and hold all the corresponding buttons to activate selected mode Bootloader = VolumeDown + PowerButton Triggered Bootloader = VolumeDown + BackArrow + PowerButton Hardreset = VolumeDown + OK + PowerButton
__________________
- RX8 -
When someone helps you out, don't say "Thanks" click -----> [TUTORIALS] EVO Full Root|OTA Root|Nand Backup/Restore|Flashing|for n00b's + videos |
This post has been thanked 6 times. |
|
||||
Re: HOW TO: Recover a Diamond that won't get past the boot screen! (Instructions)
Thanks for this guide! You saved my phone.
I had a problem - it wouldn't flash. The RUU kept saying the phone wasn't connected, even though the rainbow screen said "USB" when I connected it. It said "serial" when it wasn't connected. Here's what I did to get it working again, one of these things or a combo did the trick: -Follow instructions on page one of this thread to get phone into rainbow mode -Disconnect, reconnect phone from PC -Using WinRAR, extract the Sprint stock RUU (_HTC Touch Diamond (Sprint)_HTC Touch Diamond MR 2.00.651.7) -From extract, run RomUpdateUtility.exe -RUU went further, but gave another error. -New option was to recover, select this -RUU said to diconnect phone, reboot, reconnect, but don't do this! -I disconnected and reconnected again but did not power off because it was already at the rainbow screen Hopefully this will help someone else. |
|
|
|