PPCGeeks
Page 4 of 5 « First 23 4 5
Show 40 post(s) from this thread on one page

PPCGeeks (http://forum.ppcgeeks.com/index.php)
-   CDMA Diamond Development (http://forum.ppcgeeks.com/forumdisplay.php?f=67)
-   -   [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED] (http://forum.ppcgeeks.com/showthread.php?t=50396)

dcperdue 12-24-2008 03:55 PM
Re: [12/23/2008] Glossman Pro v1.0 with Custom Blue UI [Sys OS 20940/20931]
 
AMEN!

I hope the folks over at the kitchen factory make this phone supported like they did with the 6800 and the touch to allow cricket as the provider. I have a really nice cricket rom for the touch that was based off a chem kitchen. If I had the time to figure out how to extract the current rom with setup off the diamond im using now the cricket users would love it.

Glossman 12-24-2008 08:58 PM
Re: [12/24/2008] Glossman Pro v1.1 with Custom Blue UI [Sys OS 20940/20931]
 
File is uploaded! Have at it!

shortbus182 12-24-2008 10:57 PM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
Very nice looking interface, but very buggy. I gave it up after 3 hard resets. Rom loaded initially, but hung twice after selecting settings and then programs tab. Then would not complete hard reset..got stuck in preparing phone for first use screen. Fortunately, I had caulkins 3.5 in memory and was able to boot from that. It is a promising rom, and after some bugs are worked out, I might try it again. Thank you for your effort, and good luck in the future.

Glossman 12-24-2008 11:05 PM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
Quote:
Originally Posted by shortbus182 (Post 599411)
Very nice looking interface, but very buggy. I gave it up after 3 hard resets. Rom loaded initially, but hung twice after selecting settings and then programs tab. Then would not complete hard reset..got stuck in preparing phone for first use screen. Fortunately, I had caulkins 3.5 in memory and was able to boot from that. It is a promising rom, and after some bugs are worked out, I might try it again. Thank you for your effort, and good luck in the future.
The carrier customizations do take several minutes to run. The first time I booted that ROM, I thought it hung, too. It's important to give it the time to load everything after a flash and hard reset.

I'm running that ROM now, and have not had any hangs. How long are you giving it?

shortbus182 12-24-2008 11:39 PM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
well, I would like to try again, but it seems my phone is now bricked. It will not get past boot screen now. Any ideas?:violent2:

Glossman 12-24-2008 11:49 PM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
Quote:
Originally Posted by shortbus182 (Post 599467)
well, I would like to try again, but it seems my phone is now bricked. It will not get past boot screen now. Any ideas?:violent2:
Oye...

Follow this procedure, and have a known good ROM available to flash:

Pop the back cover off the phone. Hold the phone over your stomach (no joke!) using your body to press the stylus in the reset hole...While you're doing this, use your left hand to press the Volume down and power buttons at the same time WHILE using your right hand to push the left arrow button (the one above the hang-up key). Do all three of these things simulataneously, and you'll be in bootloader mode. Then, go ahead and flash from your PC as you normally would.

I'll pull the ROM and do more testing.

shortbus182 12-25-2008 12:04 AM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
Quote:
Originally Posted by Glossman (Post 599480)
Oye...

Follow this procedure, and have a known good ROM available to flash:

Pop the back cover off the phone. Hold the phone over your stomach (no joke!) using your body to press the stylus in the reset hole...While you're doing this, use your left hand to press the Volume down and power buttons at the same time WHILE using your right hand to push the left arrow button (the one above the hang-up key). Do all three of these things simulataneously, and you'll be in bootloader mode.

I'll pull the ROM and do more testing.
I have tried this method a few times now...problem is my computer no longer sees device when connected via usb. I was planning to do this, reformat internal memory and start from scratch. As I said, I do have caulkins 3.5 in my internal memory. After going into bootloader mode, rom will update to 100% and proceed to black touch diamond screen where it seems to like there as it will now go any further. "Bricked" may not be correct term, but definitely f'd. I have flashed 10+roms with no issues until now.

Glossman 12-25-2008 12:31 AM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
Quote:
Originally Posted by shortbus182 (Post 599514)
I have tried this method a few times now...problem is my computer no longer sees device when connected via usb. I was planning to do this, reformat internal memory and start from scratch. As I said, I do have caulkins 3.5 in my internal memory. After going into bootloader mode, rom will update to 100% and proceed to black touch diamond screen where it seems to like there as it will now go any further. "Bricked" may not be correct term, but definitely f'd. I have flashed 10+roms with no issues until now.
Are you running Vista?

Also, I was able to get my phone to hang. I did a hard reset, then a soft reset during the carrier customizations. Once it rebooted, I had trouble with intermiitent hangs too.

The odd thing about this is, it's a Caulkins 3.6 kitchen ROM, and I've made no alterations to any of the system or OS files. These are superficial interface changes using OEMs and cabs. I'll follow up with Calcu to see if he's aware of any of these problems.

I am sorry for the hassle on this.

Glossman 12-25-2008 01:14 AM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
1 Attachment(s)
Quote:
Originally Posted by shortbus182 (Post 599514)
I have tried this method a few times now...problem is my computer no longer sees device when connected via usb. I was planning to do this, reformat internal memory and start from scratch. As I said, I do have caulkins 3.5 in my internal memory. After going into bootloader mode, rom will update to 100% and proceed to black touch diamond screen where it seems to like there as it will now go any further. "Bricked" may not be correct term, but definitely f'd. I have flashed 10+roms with no issues until now.
I don't doubt you're having issues, however, I noticed that, as of 9:11 PM, PST tonight, no one has downloaded my ROM, according to my Megaupload account. You may want to double check the .rar file you downloaded, just to be sure.

See my screencap of my Megaupload account below.

dcperdue 12-25-2008 02:06 AM
Re: [12/24/2008] Glossman v1.1 with Custom Blue UI [Sys OS 20940/20931] [UPLOADED]
 
I downloaded it but didnt install it after reading this.

I hope that other guys phone isnt bricked.


All times are GMT -4. The time now is 05:58 PM.
Page 4 of 5 « First 23 4 5
Show 40 post(s) from this thread on one page

Powered by vBulletin® ©2000 - 2025, Jelsoft Enterprises Ltd.
©2012 - PPCGeeks.com


Content Relevant URLs by vBSEO 3.6.0