I had similar problems with other 6.5 roms, the solution at least for me was this.
1. Flash stock rom (when done as soon as it reboots take off battery)
2. Put battery back on after 10s and press volume down + center + power
3. Follow instructions on screen to hard reset
4. Allow boot and wait complete setup and let carrier cust. to run
5. Open bootloader screen (volume down + power + reset or turn off phone volume down + power )
6. Flash 6.5 rom (when done as soon as it reboots take off battery)
7. Put battery back on after 10s and press volume down + center + power
8. Follow instructions on screen to hard reset
9. Allow boot and wait complete setup and cust. to run
Also note that some roms are only for sprint or other carriers and some are universal but you need to install carrier cab.
Hope this helps
Quote:
Originally Posted by liriel
Well, I gave MR5 a shot, but encountered nothing but aggravation. It installed fine, but would freeze up after varying periods of use (0-3 hours) requiring a soft reset. Following the soft reset, I would get a the standard windows today screen (not TouchFlo or Titanium). No matter where I clicked on the screen I would get the TouchFlo notification screen, which was unresponsive - I had to hit the home hardware key to return to the Today screen. When I initiated another soft reset, the device would hard reset and the whole process above would repeat itself. I tried reflashing several times. Here is the flash process i used:
1. Clear storage (and internal storage)
2. Flash to stock ROM (no shipped ROM is available for my carrier Bell)
3. Flash to MR5
4. Clear storage (and internal storage)
After a while I decided to flash back to 4R3BORN (directly from MR5) and still encountered the above problems, so I followed the above four step process but replaced MR5 with 4R3BORN. So far so good...
I will wait until MR5 is out of beta before trying again.
|