[mikenbetts]

Last night I sucessfully upgraded my PPC6700 from WM5 to WM6.5. Using the PPCKitchen the process went flawlessly!. Per the recommendations in "Tips and Tricks" I created and flashed a simple configuration just to learn the BuildOS process. Today I went back to my build and added additional features that I want on my 6700. The new configuration properly went through the build process right up until I got the pop-up screen with the picture of the 6700 and the remaining simple instructions on how to complete the flash update. Almost immediately after I pushed the next button I got the "blue screen of death" on my laptop as it crashed and rebooted. When I checked the 6700, the screen was blacked out with only the faint image "Serial V1.00" and it now will not soft reset or hard reset. Ofcourse I no longer have an active sync connection so re-running the flash procedure seems to be out of the question. Is there any way to resolve this tragic situation or have I just created an expensive paperweight?

Thanks,
Mike