[sd_wireless]

I've done my research (or at least I think I have) and have gotten as far as I can in getting this device onto the Verizon network.

With props to scottemick, this is what I have done:
1. Get the MSL code from GetSPC inputing your ESN and it outputs the MSL.

2. Put your phone in DIAG mode (##3424# ##3424 Send, or #*#3424). If it is a sprint phone, the first one will work.

3. Run QPST (you will need the MSL you obtained from getSPC

4. You may want to save the phone's configuration if you ever want to roll back to the SPCS config. Anway, Change the MSL to 000000 and write it back to the phone.

5. then run the Hard-SPL-MFG.exe program, paying attention to when it tells you to disconnect and reconnect your phone.

6. Then install your ROM. Now when the PDA boots it displays the Verizon logo.

But this is where I am stuck. How do I do the following step? What settings do I need to define, and what do they need to be set to?

7. Now, you will need to configure service by going into DIAG mode again (probably need to use #*#3424 now) and using QPST change the service information to that for Verizon or whatever carrier you want. I had it easy, I plugged in my Samsung Hue R500 and copied the service information off of that one.

I tried skipping the step above and called Verizon, as outlined in the step below.

8. If you get all the service information right, you should be able to call verizon, give them the ESN. If they give you slack, wait a bit and call back. Persistance is the key. Then you can do *228 for OTA programming.

When I gave tech support the ESN they said it wasn't a valid ESN that they could not activate the phone.

Please help... Can this phone be activated on the Verizon network? If so, what remaining steps to I need to take?