Hello,
I have successfully updated my phone(xv6700)to MOB 6.0/6.1 several times in the past and I have a problem that I can't figure out and need help. I can't seem to communicate from the phone to the computer. I have tried several computers and resetting and hard booting same result.
When I setup and install Active Sync and plug the xv6700 into the computer it gets Device not recognized. After soft resets and hard resets same result. When in Bootloader mode the same result device not recognized (Flashing from an older 6.0 ROM I have saved)
The device will recognize the USB because one I can charge and two in Bootloader mode it recognizes Serial\USB. The USB port is in good condition it must be a software issue but I'm not into software on that level.
I have an older ROM saved and in Bootloader mode it's give the same message when trying to flash it.
I can boot my phone normally and works fine. I've read about Flashing from the SD card but not sure how to intialize the SD card on power up to flash from it, and what files would be need to do this.
Any help would be appreciated.
Cheers, Harvey
solo624@msn.com