[n8mack33]

Originally Posted by sndtubes

After stabbing my finger while trying to open the box with a sharp precision screwdriver, I opted to cut the jacket on the small piece of cable going from the connector to the box instead. I found the blue wire, cut it and then used heat shrink tubing to seal the cable again. It works fine although I haven't tried audio yet. The old camcorder cable I had on hand wasn't wired properly, but I found video on the red audio wire. I have tried it so far with my Redfly and it works pretty well. Interestingly enough, I have never experienced the blue flashing with Coreplayer that everyone talked about until now. I see it using the video out. It's a Coreplayer issue, though, not video out issue.

So, if you guys don't want to break the box, you don't have to.

This is the method I used to. For me, it was much easier than trying to open the box or breaking pin 4 (which I also did).