Quote:
Originally Posted by lbjohnny
Ok. I got into the dmrouter mode. When I go to add ports - com 4 is not listed. Just Com7 USB/QC Data Modem & Com 8 USB/QC Diagnostic
If I try to add com 4 I get error message enabling."the port may not be worjking properly.... (-2147467259)
It must be a setting I have somewhere. Should I go back to the original ppst?
|
I posted the answer to this a few posts back....
It doesnt matter if it shows on COM 4. Thats only on the OP's computer. If my computer had 4 com ports already then this may show up as 5 and 6. If you have active sync already and sync with bloothtooth then you may be using 5 and 6 so it will show up as 8 and 9. Etc etc etc... If I had 8 com ports then this may show up as 10 and 11... To be honest with you as long as it shows up and you connect to it you are good. When you try to connect to COm4 and get that error its because you already stated the phione is on COM7/8. Just keep going.
The port in QPST has NOTHING WHAT SO EVER TO DO WITH GPS PORTS just so you know. IM sure this question will be asked again as soon as a new page is started.