View Single Post
  #528 (permalink)  
Old 12-11-2008, 02:42 PM
ScrapMaker's Avatar
ScrapMaker
VIP Member
Offline
Location: Austin, TX
 
Join Date: Oct 2007
Posts: 1,389
Reputation: 740
ScrapMaker knows their stuffScrapMaker knows their stuffScrapMaker knows their stuffScrapMaker knows their stuffScrapMaker knows their stuffScrapMaker knows their stuffScrapMaker knows their stuff
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Re: Touch Pro Build Date

Quote:
Originally Posted by flyers2114 View Post
Hrm.... all of them? Including screen insensitivity around the borders? (You can open up notes, and try drawing a line to the borders with your thumb, if you aren't sure.)

Just tried this....it is fine up and down and right to left....but yes it does stop short about an 1/8th of an inch from left to right.....never noticed this issue until you brought it up....




That's really great to hear. Perhaps the Pro will be a worthwhile phone eventually. Other people have had the same build-date as you, but had problems, so I don't think it's the actual build date we can go on. I wish we could figure out what plant made them...
Just another FYI.....I tested the over heating issues I had before....I have none that I had before.....before it would heat up at random and when I ran internet or music and vids for a few minutes it would also heat up.....so far so good....keeping fingers crossed....[/quote]

Thanks for giving me hope. If the X1 doesn't pan out, I will have to try the Pro again.

To be 100%, you calibrated the screen with the stylus, (so it's accurate,) then held the phone in portrait mode, and drew a line in Notes, from the center of the screen to the left side of the screen, and without using the stylus, fingernail, or anything but normal pressure on your thumb, (like using the TF3D tab,) it went all the way to the left side? If so, you can consider my mind--blown. So far no one else has had a TP that works like this...