I just downloaded the latest 28-10-2008.zip from dzo website and unzipped the files to /storage card/ and when I try to run haret it goes into an endless loop either saying "sd init retry | mmc0: data error (-110)" and just keeps going and going.
I did remove all other instances before placing the new files on the device as well. I am not sure if the default.txt file is correct. Here it is just in case:
Quote:
set MTYPE 1667
set KERNEL zImage
set initrd initrd.gz
#
# The following kernel parameters are useful
# ppp.username - The username used to connect to the network when dialing #777
# ppp.password - The password used to connect to the network when dialing #777
# msm_sdcc.msmsdcc_fmax - The maximum frequency (in Hz) used by the SD controller
# pm.sleep_mode - The mode used when the phone is off
# 0=Power Collapse Suspend, 1=Power Collapse, 2=Apps Sleep,
# 3=Slow Clock and Wait for Interrupt 4=Wait for Interrupt
# Default is 3, use 0 for best power savings
# board-htcvogue.panel_type - Panel type used to power the panel off and on
# 0=Don't power off the panel (Default)
# 1=Hitachi 2=Topoly 3=Samsung
#
set cmdline "ppp.username=mobile@jamamobile ppp.password=telecom"
# msm_sdcc.msmsdcc_fmax=32000000 pm.sleep_mode=0 board-htcvogue.panel_type=1
# fbcon=rotate:1
# console=ttyMSM0"
boot
Edit: I tried reinstalling the .cab installer and it works fine. I then removed the entire presence and installed the newest (28-10-200
version and it gets the same error again from above. Tried replacing zImage from the .cab installer with the new one and again same error but if I just use the one that came with the .cab then it works.?