View Single Post
  #4 (permalink)  
Old 10-27-2008, 07:52 PM
Krayziepop's Avatar
Krayziepop
Regular 'Geeker
Offline
Location: Everywhere
 
Join Date: Feb 2007
Posts: 298
Reputation: 380
Krayziepop is becoming a PPCGeeks regularKrayziepop is becoming a PPCGeeks regularKrayziepop is becoming a PPCGeeks regularKrayziepop is becoming a PPCGeeks regular
Mentioned: 0 Post(s)
Tagged: 0 Thread(s)
Send a message via AIM to Krayziepop Send a message via MSN to Krayziepop Send a message via Yahoo to Krayziepop
Re: CANT FIND MY PROs ESN

Just an FYI, but the GetSPC program doesn't work on the Diamond/Pro. You will need a registry editor like PHM Regedit, then follow these instructions. Good luck

Change the following registry entries in:
HKEY_LOCAL_MACHINE\SOFTWARE\HTC\ATDbgLog
Enable: 1
LogMode: 1

* Wait a about 10 minutes (more time will not hurt), and soft-reset.

* Check to see that the file \Atlog\ATDbg0.txt has been created.

* Return the values back to what they were (most likely 0) waiting the same amount of time as above.

* Look in the ATDbg0.txt file and you should see a log of commands sent to the CDMA radio and there should be something like this somewhere in the file:

~~~~~~~~~~~SNIP~~~~~~~~~~~~
00:00:00 Tx:AT+HTC_RMSL=0\r
00:00:00 Rx:+HTC_RMSL: (###THIS WILL BE THE MSL###)\r\n0\r
00:00:00 Tx:AT+HTC_ROTKSL=0\r
00:00:00 Rx:+HTC_ROTKSL: 123456\r\n0\r
~~~~~~~~~~~SNIP~~~~~~~~~~~~


The numbers next to the Rx: +HTC_RMSL line should be your MSL
Reply With Quote
This post has been thanked 34 times.