|
taken from kirvin's readme file included with one of the roms:
1. Hard reset your phone. Hold down both soft buttons with one hand and poke the reset hole with the other, ideally while holding a stylus in the second hand, unless you have really pointy fingers.
2. Put your phone in Bootloader mode. This is a special condition that prepares the phone to rewrite the ROM. While holding down both the power and record buttons, poke the reset switch, again with a stylus. The backlight should go off and the screen will say "Serial". When you put it in the crade, the screen will change to say "USB" and the backlight will stay off. This is normal. Wait for Windows to recognize the new USB device before moving on.
3. Run the rom EXE file. Keep clicking Next until it's done. Do NOT remove your phone from the cradle until it tells you to
4. When told to remove your phone from the cradle, pull it out and hard reset it again. Congratulations! You're running whatever rom you downloaded and flashed the ppc with
|