[mr_hyde]

Greetings everyone. This is my first post but I have been a moderator in other forums and I appreciate the mantra of read, read, read. I've been tinkering with electronics since cell phones weighed 12 pounds and came in large bags but it never occurred to me that I could customize the software on a phone until I bought my xv6800 and was misled by the sales guy that it could tether to my mac laptop. I wasn't too excited about spending $60/month for the feature anyway so google brought me here!

Here are a few things I have learned in the few days since I started to read here.

1. Before doing anything to the phone I used PIM Backup to save all of my contacts and messages. This worked great and I saved everything to the memory card. All of this info is erased doing any flashes so the backup is a must.
2. To do anything with the phone, you must first unlock the unit. I used hard-spl-mfg and it worked fine.
3. After you unlock, you can load other ROM setups on the phone. I wanted to get around verizon's crippled WM6 so I loaded dcd-1.6.7_vzw. This worked fine too.

The phone worked fine for a few hours and then it started to have issues waking from sleep. It simply won't. I have to do a reset (with the stylus in the hole at the bottom) or pull the battery. It will boot up and act fine - work flawlessly with everything until the sleep button is pushed (or it goes to sleep from inactivity). Then it will not wake. Incidentally, it won't ring through calls or messages in this state either.

I got impatient when unlocking and loading dcd167 and I don't think I have a proper factory backup to restore to. I have a lot of reading to do but if anyone sees any obvious errors in my very limited understanding of the process, please point it out. I've initially searched for 'wake' and 'sleep' and 'froze' and not found specific posts on my issue.

I'm excited to be here and appreciate the opportunity to learn some new skills. Thanks!
-hyde