|
bbobrian: you need to copy the files from an install (as install the apps and copy the bits, then hard reset to clear things out and then re-copy)or extract them from a cab. So for xscalar, just take the exe and copy it to the windows folder. Also for MS Voice command, all the other files are in place and registered, so you would only need to copy the EXE into the windows dir as well. Copy a file to a rom dir will supress the rom version with that that you copy. This allows for upgrades to system files and such.
There was an issue where the storage card was having issue with a 3rd party app copying over the storage drivers. I believe this was one of the SPCS cabs set to run at first boot. I can't remember the file right now but there was a fix to it on this forum. It to had to do with files copying over the system Rom files, but they were earlier versions and thus causing issues with aku 3+. This may not be your issue, but a good place to start. I have not experienced any stroage card issues. The only issue I have seen so far is an ocasional lockup after a soft reset. I think its timing with the other apps along with the GWES change, but I am still looking at it.
-saridnour
|