View Single Post
  #19 (permalink)  
Old 11-17-2011, 12:52 AM
elesbb's Avatar
elesbb
Super genious in training
Offline
Location: PA
 
Join Date: Jun 2010
Posts: 1,198
Reputation: 1600
elesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on repelesbb is halfway to VIP status based on rep
Mentioned: 42 Post(s)
Tagged: 0 Thread(s)
Re: Flash will not progress past 0%

Quote:
Originally Posted by boggsie View Post
This is precisely where my thoughts are gravitating ... something goofy happened and even though HSPL reads OliNex, the phone is behaving as if I am trying to flash a non-carrier or custom ROM on a locked-down phone. This is what made me think to try and flash the stock Sprint RUU again ... unfortunately, to no avail.

Problem with unlocking is that you must start out in Windows Mobile (Activesync or WMDC) so that the phone can load and work from a temporary bootloader which runs in RAM. This temporary bootloader then permits flashing the unlocked bootloader on to EMMC. If you can't get into Windows Mobile, you can't unlock.

Not sure what to do at this point except get my Touch Diamond out of the box. I'm not giving up my legacy SERO, that is for sure. $30 / month ... with pick 3 and 6pm nights and weekends. I'll keep my eyes open for another TP2 that is in good condition.

Best regards,
-boggsie
Olinex has a manual method to unlock . worked perfect for me when i had a curropt ROM image from an incomplete download . i could get into bootloader but no further , so i unlocked from bootloader and flashed my custom rom on no troubles whatsoever
Reply With Quote
This post has been thanked 1 times.