Thread: is there a way to recalibrate the screen or a known good sprint rhod 400 ts-calibrat.
View Single Post
  #1 (permalink)  
Old 07-28-2011, 12:25 AM
t0mmyr's Avatar
t0mmyr
Threadstarter
Offline
Location: Southern California
  
Join Date: Feb 2008
Posts: 1,909
Reputation: 4798
t0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributionst0mmyr should be added to the payroll for their contributions
Mentioned: 1 Post(s)
Tagged: 0 Thread(s)
Send a message via AIM to t0mmyr
Question is there a way to recalibrate the screen or a known good sprint rhod 400 ts-calibrat.
I just upgraded to FRX07 (clean install fresh files) without a ts-calibration file on my root sd card so that it would prompt me to calibrate the screen 1st boot...all went fine, i tapped all 5 points as closely as i could with the stylus right on the crosshairs but now it seems as if my lower half of the screen is mis-aligned vertically, if i tap an menu line or something usually something half an inch below clicks as if my stylus or finger was in a different spot, however the top half of my screen feels well calibrated....

is there a good way to recalibrate the whole screen? or perhaps someone has a good working ts-calibration file for the Sprint CDMA Touch Pro2 (Rhodium 400) that they can share? THANKSSSS
__________________

Reply With Quote