[paustin]

- Additional Information -


Ok, here is the process that I follow.

I run Titanunlocker.bat. After following the steps, I hit the tri color screen, that indicates TITAN.

The .bat file indicates the following.


####
Your device should now be in 3 color screen showing the SoftSPL bootloader
####
.
####
You must now disconnect and reconnect the device from your PC
Do not make any other changes at this time, but don't skip this part.
####
.
####
*** Repeat: You MUST disconnect and reconnect the device at this time
####
Press any key to continue . . .

>> I disconnect and reconnect. I pause about 15 seconds and hit the spacebar. The .BAT file proceeds with the following message.

.
.
####
Starting the Rom Upgrade Utility. Please follow the steps on the
RUU to complete the unlocking process. Press enter when complete.


>> The PDA remains on the 3-color screen. On the PC, the 'PDA Phone ROM Update Utility 3.16.4.2' loads. I hit next and the instructions indicate that I must have the phone connected with an ActiveSync connection. Since I am in on the 3-color screen, I don't have an Activesync connection. I assume that this is where I need titan_exitbl.exe.

I go into TaskManager and end Rapimgr, wcescomm, and wcesmgr.

I run Titan_exitbl and I get a pop up saying that data has been sent and the device should boot. The PDA self-reboots.

The PDA boots to my normal OS. (( How do I know my phone is unlocked?! ))

I rerun Activesync and re-establish a connection. I then run the RUU to load the ROM. The screen eventually winds up at a grey screen with a progress bar. After about 3 minutes I get the error that I refer to above.

Again -- any help would be much appreciated.