[m2maynard]

Iposted this on XDA but figured since most of the devs are primary here on PPCG so I am reposting this over here.

I have a ATT GSM Tilt 2 (RHOD300) and get a typical boot loop when attempting NAND with the SIM.

So I went ahead and installed NAND without the SIM then tried again with it in place after the install. It boot loops where it asks to hold volume up to get into recovery. I had to loop it a few times because it bounces right after and is difficult to read unless anticipating it. So next loop cycle I was reacting and clicked the volume up button and hit it a few times right at the option to click for it and it got past the boot loop and booted into Android!

However, it doesnt seem to see the SIM card so my guess is it was looking at the SIM as the SD and couldnt mount so skipped ahead to boot.

Anyway to change the order of what SD gets mounted 1st? I would think if it found the sd 1st instead of the SIM it could get past this point?