|
Re: NAND Boot Testing - 01-07: Panel power on/off fixes
I'm here and ready if someone gives me a quick run down. I see the mtty thread on page 5, and I can do all this prep work/driver install stuff now, but I have no linux environment set up. If someone wants to hit me up on AIM or IRC, I'll start digging in and see which side of the fence my Rhod400 is on. Is it just using mtty to flash the NBH? I'm guessing all the tinboot requirements and such are already in the NBH?
Edit:
Cmd>set 14 0
HTCST ÚÈÒHTCE
Cmd>task 32
Card inserted
SD clk rate 19MHz
Cmd5 CMD_TIMEOUT
SD clk rate 144KHZ
SD 2.0 TURBO mode : SD Clk rate 24 MHz
SD Init OK
Card inserted
SD clk rate 19MHz
Cmd5 CMD_TIMEOUT
SD clk rate 144KHZ
SD 2.0 TURBO mode : SD Clk rate 24 MHz
SD Init OK
Level = 0
Cmd>task 37
Buffer = 0x85340000, Size = 0xA77AE
Cmd>task 29
Format BINFS start
CE start start block=384, total block=3712
ERASE block 2387 FAIL !!!
ERASE block 3348 FAIL !!!
Write 0xFF start page=0x6000, total page=0x3A000
Format BINFS end
__________________
 My thanks button is sleeping. Do not disturb.
Last edited by Boominsvx; 02-22-2011 at 01:16 AM.
|