Thread: Call Issues...
View Single Post
  #3 (permalink)  
Old 12-17-2010, 01:30 AM
arrrghhh's Avatar
arrrghhh
Testing Extraordinaire
Offline
Threadstarter
 
Join Date: Mar 2007
Posts: 3,604
Reputation: 7360
arrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the communityarrrghhh is a trusted member of the community
Mentioned: 7 Post(s)
Tagged: 0 Thread(s)
Re: Call Issues...

Just happened. I was going thru the logcat... and this system image has JIT enabled. So that's what caused the reboot. I'm going to double-check my damned system image from my supposed clean folder here. I'm wondering if that build.prop that I'm mounting is enabling jit and superseding the system image...

Either way steveholtam, you do not have a clean FRX03 image... Where did you get it? It has neopeek in the name...

Update - just confirmed, that would make sense as well - the mounted build.prop file with jit enabled would take precedence over the system image file. So if I go back to a clean FRX03 system image the issue with reboots and speakerphone turning on etc should go away, but I still have the problem of the radio flaking and deciding to drop in the middle of a call - and I don't mean from a dead cell spot, I mean the radio has an x on it next to the signal bars. Then it'll go back to full service...

Last edited by arrrghhh; 12-17-2010 at 01:35 AM.
Reply With Quote