Quote:
Originally Posted by fishingmedic
I'm using Windows. I'm also not sure how to edit the file.
|
in windows use (WORDPAD)
IT'S GOING TO LOOK LIKE THIS. SEE BOTTOM PAGE
# General parameters
general{
renice=1 # Run the renice script to inprove call answering
}
#compcache related parameters
compcache{
compcache_en=1 # enable(1) or disable(0)20 compcache
cc_disksize=100 # Ram swap disksize - any number between 1 to 98 should work; default is 1/4 of the RAM (24)
cc_memlimit=64 # Limit the memory usage for backing swap (cc .5x known issue-defaults to 15% of total RAM)
cc_backingswap_en=0 # enable(1) or disable(0) backing swap
cc_backingswap=/dev/block/mmcblk0p4 # pointing to the backingswap partition device, swap
}
#create swap file for compcache or linux swap
swap_file{
swap_file_en=0 # set to 1 to create swap file
# set to 0 to del the swap file
linux_swap_file_size=32 # swap file size in MB
linux_swap_file=/sdcard/swapfile # pointing to the swap file location ( must be /system/sd/)
}
#Linux swap parameters
#
# linux swap can only be enabled if cc_backingswap_en is set to "0"
#
linux_swap{
linux_swap_en=0 # enable(1) or disable(0) linux swap
linux_swap_partition=/dev/block/mmcblk0p4 # swap partition device
}
#virtual memory
sys_vm{
sys_vm_en=1 # enable(1) or disable(0) virtual memory configurations
swappiness=0 # default 60
page_cluster=0 # default 3, (0 since CM3.9.6+)
laptop_mode=5 # default 0
dirty_expire_centisecs=3000 # default 3000
dirty_writeback_centisecs=1500 # default 500
dirty_background_ratio=3 # default 5
dirty_ratio=5 # default 10
vfs_cache_pressure=200 # default 100 (tendency of the kernel to reclaim cache memory)
overcommit_memory=1 # default 0 (0=Heuristic 1=Always overcommit 2=Don't overcommit)
overcommit_ratio=80 # default 50 (% of Physical+Virtual memory to allow allocation)
}
# custom shell commands, these commands run last
custom_shells{
chmod 777 /etc/dbus.conf
#echo "Hello!!!" # example
mount --bind /sdcard/libGLES_qcom.so /system/lib/egl/libGLES_qcom.so
}