Quote:
Originally Posted by nvrnugh
So you can't do the rom with the prl update and just be done with it??
|
no...the PRI update comes from Sprint, I cannot include in the rom
Quote:
Originally Posted by jelive
OMJ
Have had several attempts at Handsfree Activation and tried just about every recommendation...no go for PRI 1.40
Is there any possible connection to the *.img file or my location. Clockwork is showing 2.5.01 Swear I had later version before I started all this PRI update stuff. Someone also recommended older EPST version...would that screw me up in any way?
Jim
|
anythings possible, have u tried backing up, then flashing the stock rooted rom, then ##786#?
Quote:
Originally Posted by yaaah_hoo
OMJ or Anyone,
When I fastboot flash userdata data.img
I get FAILED (remote: data length is too large finished. total time: 0.004s)
|
others have seen this too, how big is your data.img? it could either be too big or could be from not wiping over several roms, causing it to bloat
as much as a pain as it is, when I first starting doing this, I wiped , then flashed then setup all my settings & apps, then took another backup....the data.img was considerably smaller. So I think it's best to start w/ a clean slate.
Since I've started using this process, I no longer have to backup anything via titanium or mybackup pro, cuz when I write the data.img, I'm back where I left off.....but u have to go through the nand backup each time b4 flashing
Quote:
Originally Posted by touch_rules
Ok, now that I'm home and ready to try this I just took some time to read it a little more clearly and.....
Is this to update the PRI or to flash your new rom?
Reason I'm asking is the because the step that says "-flash new ROM (DONT REBOOT)"
Thanks again for all the help.
|
this procedure is to restore all your settings, apps etc, after flashing (and wiping)