Someone posted over at WinMo-Experts and this was what Bengalih had to say.
Quote:
|
Originally Posted by bengalih
Quote:
|
Originally Posted by wisniak
Hi Bengalih,
Now that I've done an HR, I do see that NATF included both 2.0 and 3.5.
So back to square one: what could be that error message from the Tiered run?
I'll try to recreate it later, but maybe you could check too.
Thanks again.
|
SASHIMI checks that NetCF is installed before allowing you to run Tiered AutoInstall. In order to check to see if it exists, it checks for the existence of the following registry value:
"Software\Microsoft\.NETCompactFramework\Installer "
"GACPath"
If that registry value doesn't exist, then it tells you that NetCF is required. I chose that registry value as it exists from an install of both the NetCF 2.0 and 3.0 official cabs. It also exists on devices with built-in 2.0. As far as I know, nothing has 3.5 built in yet (or at least not on a Tilt).
I just tested SASHIMI again using the 3.5 official CAB, and that REG key exists and Tiered autoinstall ran properly.
If that registry key doesn't exist on NATF ROMs, I would ask him why, as it should (since it is part of NetCF).
Any other error you are getting I haven't experienced, so you will have to post specific info. |
When I checked mine, it has under Software\Microsoft\.NETCompactFramework -> REG_DWORD Values 3.7.8345.00 and 3.5.9198.00
However, Software\Microsoft\.NETCompactFramework\Installer, *blank
It has a folder,
.NETCompactFramework\Installer\Assemblies\Global\ *blank as well
.NETCompactFramework\Installer\Assemblies\ROM\ *blank as well