[hammergunner]

when i replaced my digitizer since i wanted to get rid of the Verizon logo

all i did want use a q-tip with normal rubbing alcoholic and then removed all the left over adhesive

and then using a small piece of card stock paper(or note card) use clear tacky glue and just place a very small amount on the LIGHT BLUE parts in the picture

GLUE - Aleene's Clear Gel Tacky Glue
(USE AT ROOM TEMP WHICH IS (65-75F)
(149-167C)

and it will dry in 24 hours and takes 7 days to cure

YOU MUST LET IT AT LEAST DRY FOR 24 HOURS FIRST BEFORE USE!!!!

and let it fully cure for 7 days, i say use your buttons for everything so the glue can cure

ONLY USE THIS GLUE, double sided tape makes the digitizer stand out, and super glues will make it impossible to remove the digitizer again without damaging the out casing