[champ052005]

What screen protector are you putting on?

It depends, because if you are putting on a skin then there should be instructions with the box.
Simple way is to dip the different parts in warm water. Clean your hands, make sure they are wet. Take the individual piece out of the water, let the access water drip off and place it on the phone. The wetness will help you maneuver the part onto the phone. Then if you have bubbles, take a flat surface like a credit card, and remove them. Start at the center, and work your way to the sides of the phone.

For a pure screen protector, you can do that same method.

The shower trick works nice too. First turn the shower on and wait until the bathroom gets steamy. This will remove all the dust from the air, so you will get a perfect installation.

NOTE: For the shower trick, I always worry to trip the water sensor. So what I do is cut a piece of paper a little bigger than the water sticker, and then place the paper on top of the sticker and tape the paper on top. This will protect the sensors from going off. Make sure you do no put tape directly on the water sensor, it will rip if off. Hence the paper.

Hope that helps man.