Right now I'm trying to superCID my Telus Vogue and I'm using these steps from Mr.X's thread.
Quote:
SuperCIDing
1. Disable USB in Connection Settings of Active Sync
2. Boot The Phone in bootloader mode.
3. Connect Phone to PC
4. start mtty.exe
5. Select All Default and Connect to USB in drop down box and Shoot the Following Commands (All Commands are case Sensitive)
6. run command rtask a : After this Command Phone will not Display any thing
7. run command echo_on : even though nothing is shown to screen
8. run command readCID : in Telus it will display TELUS001
9. run command writeCID 00000000 : Set CID Value to 00000000 replaces TELUS001 in Sprint (This make PPC Radio Security Level to Zero)
10. run command readCID : This will Display the Update CID as 00000000
11. run Command retuoR : This will return to Original Boot Loader State
12. run command rtask c : This will Activate Phone Radio and then we can Access Diagnostic Port and Set NV Items
Issuing rtask c Command Put the Radio of Phone to ON State so we can have Radio NV Command work properly
|
My problem is where you open mtty.exe. When I open it, it tells me to select a COM port but I'm not sure which one to use. Also when I go to type a command the whole program freezes and I get no where. Any suggestions would be greatly appreciated.