Quote:
Originally Posted by makkonen
Everything from that should also apply to the RAPH800. Chrialex said it just worked for him without setting anything, so be sure to give that a try. phh pushed a change to the RIL code that might cause it to get the PPP authentication settings from the APN data, so give that a try, too (those changes haven't made it to the RHOD400 RIL yet, AFAIK). Otherwise, use the instructions from gmfeny's link. |
This was in response to a response made about my original question. It's pretty difficult for me to keep up with this because there is not a dedicated metropcs thread for either the touch pro or touch pro 2 android port but i am tryign to read through all the fragmentation. From what "i read" in the other thread, it offered suggestions but there were no definitive A) use these settings B) data works, I understand it's still in dev and the metro information is getting set aside because of it's limited userbase. I posted a reply in the other thread and will report back and hopefully update the wiki with definitive how to settings. So i'm going to go **** around with this while i actually have time to do it right now and get back to you guys.
Is anyone in this thread currently involed with the dev side of this port? I would love to get involved i have programming experience and phone hacking/development experience. I think that maybe if we could get a pseudo diagnostic winmo native rom and find out what and how winmo uses the camera and gps ..etc it would make the port of those features easier. Though, these are judt ideas coming from no knowledge base of the port or how the roms and cooking them actually works.