[flyers2114]

Originally Posted by alfredo-x

just in case anyone is wondering why i wanted the 1% driver removed and replaced with a 10% increment driver, it's because everything your device does is done with electric signals, including the reading of your battery levels. so if you're polling the battery to tell you how much charge it has left, you are actually using the battery's energy to calculate the amount of charge left and display it to you.

now if you think about it, if the driver is going to display you some accurate 1% increments, it will have to poll the battery at least a couple of times every 2-4 min., whereas if it only has to display status in increments of 10%, it will only have to pull the battery once every 5-10 min. or so. now if you add up that in one day there's 86400 minutes, then the polling of the battery surely adds up... if it was up to me, i'd rather have a battery driver that displayed only in increments of 20%, but anyways, yeah, the polling does add it.

once i applied the new nueBattery driver, and disabled the 1% increment, my phone has stayed at 50% for over 4 hours now, whereas, in the morning it went down 35% in just 5 hours.

so yes it does make a difference, try it for yourself if you doubt it.

also, defenetly make sure you set your screen brightness to "auto-adjust"

Fiorst off i know what you are saying....but it is very minimal...not to mention you were looking for the fix when you said you do it all the time....also you just asked for the fix about 2 hours before this post...now you say you have been running it for 4 hours....I have tested this in the past and as I said it is minimal at best....

Originally Posted by gabbythe1

Does anyone have the Feb 26 version with MaxManila and will share it with me please?
Thanks

Yea it is in the Maxmanilla thread...

Originally Posted by Ragster

So far 3/7 23542 w/Cookie has been good except for a few things (Some might have been posted before, but I'm NOT looking for fixes, just puttin it out there)


2) When I installed the Sprint provisioning cab, I can't open any of the PRL/ Profile/ Firmware updates, when I press them, nothing happens

PRL and Profile are really not needed....
3) 2016 AHH lol I would run Ziggy's fix but then I lose notifications, so not a biggie

There is another patch somewhere....cannot remeber off hand but look for it...


Not sure how Battery Monitor works, but I just clicked on it and it said 78 MA on my Discharge, not sure if thats right or what lol

Anyways thought I'd share!

78Ma is pretty good.....