[Spider-Dan]

Hi. I've noticed an issue with MS Voice Command (1.6) while using the Motorola S9 ROKRs, and wondered if anyone had any suggestions.

With the headphones on and paired to my phone, if I push the Voice Dial button on the phone itself, I hear the Voice Command prompt in high-quality stereo (as if it's in headphone mode, not headset mode). If I say "Dial Abe Lincoln at home," it'll repeat "Dial Abe Lincoln at home?" (again, in high-quality stereo), and if I respond yes, the command will be executed successfully. No problems here.

However, if I push the Call button on the left side of the headphones, I hear the Voice Command prompt in low-quality through the left earphone only (as if it's in headset mode). If I say "Dial Abe Lincoln at home," it'll repeat "Dial Abe Lincoln at home?" (again, in mono). But when I say "yes," it will never, ever accept that confirmation. It simply will not.

I've tried this at home, in the car, when it's quiet, when it's noisy. It works just fine if I use the button on the phone, but it absolutely will not ever work if I use the button on the headphones.

As I understand it, there was a problem with Bluetooth headsets on the original Titan ROM (I bought mine from Sprint in Aug. '07). I recently updated my ROM to 2.17 (using RUU_TITAN_SPRINT_WWE_2.17.651.0_RS_TITAN_SPCS_1.47 .01_Ship.exe). I can confirm that whereas previously, people on the other end of the call would complain about the call quality while I was using the S9s, after this update everyone has said that the call quality is just fine. However, I'm a little annoyed by the call button issue.

Has anyone else experienced this? Does anyone have a solution?