[chstroup]

Originally Posted by Malachi

OK, thanks to Cmonex I got it fixed.

Here is what she told me:

"hi, just connect to mtty, and use: "set 16 0".
itwill be fine then "

I did it, and soft reset, and everything is fine.

Originally Posted by Malachi

yes, tried that too, but it won't connect to pc. bootloader screen shows USB, but activesync won't recognize it and RUUs wont' either.

Thanks for the effort though.

Originally Posted by Malachi

Bump. anybody?

Originally Posted by Malachi

Can anybody help me?

Long story short, I was flashing back to stock SPL, using sd card, and pulled the sd card out while it was flashing (don't ask, I seemed to forget for a moment what I was doing and realized I needed my card for my other phone Now, I have the stock SPL, shows PANT200 SPL-0.36.0000 CPLD-2 when phone starts, and says Upgrade ROM code error Please Try Again. But, if I put my sd card in it with PANTIMG.nbh SPL file, then I get a screen that says "Loading...". And that's it, left it like that forever it seems and no change.

Any idea? It won't connect to the computer so I can't flash from computer. Even QPST won't find it.

TIA,
Malachi

I am really stuck like the above quote's with the same situation. My phone is stuck in the 3 bar color bootloader which says
PANT200
SPL-0.36.0000
CPLD-2
Upgrade ROM code error, please try again.

I have attempted to load the rom using a blank, formatted sd card with the renamed PANTIMG file but that only takes me to a gray screen which shows loading but never goes any further. I have read through all the posts and see mtty.exe was the solution. I have tried using mtty.exe but not sure how to do it. i have the usb plugged into the phone and computer (which doesn't recognize it) and selected the USB port in mtty. It says the USB is closed. What can i do at this point to get out of this bootloader screen so i can flash a stock rom? Is the phone bricked??

Thanks in advance