Quote:
Originally Posted by Cokeman7
Try taking out the battery and putting it back in. Then hold down the end/power key and the vol. down button. This should put you into the boot screen. Then connect your usb cable and run the ROMUpdateUtility. It will not open the Windows Mobile Device Center but that is ok. It should reflash without a problem.
Good Luck
Ken
|
You can also flash via SD to avoid using cables and active sync and worrying about the cord getting pulled at a bad time. You can just extract and put the RHODIMG.nbh on the root of an SD, put the SD in the device, make sure power is off (pull batt & replace if necessary)then throw er in bootloader mode using the method from the post I quoted.
Once in bootloader the device should automatically go to the gray screen asking to hit power to update blah blah. Hit power (I use the top Sleep button here) and it should flash the .nbh within a matter of minutes and will then say update success somethin rather....Hit the soft reset and you should be golden.
I reccomend checking this thread if you are unawre of the SD flashing process. I rarely use a USB cord to flash anymore.
http://forum.ppcgeeks.com/showthread.php?t=95375