Re: How to clean the entire stock screen protector??
this was a post from pjninja...
for those of you who want to remove fingerprints and dust off of the sticky side:
1)take a piece of tape ( i use electrical), all you need is a tiny piece so you know which side is sticky and which isnt, put the piece on the NON sticky side
2)take some hand/dish soap (i find hand soap works best for this since its not as soapy) and put a few drops on the sticky side and use your fingers to rub the soap on really well
3) run the screen protector under warm water (not hot, just warm to the touch) let the water remove the soap, dont touch it! if you used hand soap this will work very fast and very well
4)apply the screen protector to the screen making sure the side with the tape is on top (its hard to tell which side is sticky when its wet and your fingers are wet, so this is where the tape comes in handy)
the soap will not remove the sticky stuff on the screen protector so dont be afraid to use more if you have to
if you use soap in the water like the instructions tell you to, only use about 1-2 drops of soap per cup of water, this is all it takes and using more will only make it worse
and also, NEVER use alcohol on the screen protector or the actual screen, it can damage them. soap and water will clean it perfectly without damaging anything.
personally, instead of dipping the screen protector in the soap+water solution, i like to mix up the soap and water solution in a cup and use a syringe (without a needle, just the bare plastic tip). hold the syringe like a pen and "dot" the screen(not the screen protector) with the solution and apply the screen protector. this way you dont use too much of the solution and you get better results since it dries faster and clearer without any haze/film between the screen and screen protector.
|