[lennysh]

Originally Posted by StevenLawyer

Lennysh and Yuma6700:

Well, I discovered one other bug. If you run this app via voice command when the 6700 is locked, it doesn't work. It gets to the point of the open settings screen for voice command, but doesn't exit the settings screen, which is apparently necessary in order for the settings to take effect. So the change doesn't occur unless you unlock the PPC and exit the settings screen.

I normally keep my 6700 locked while on my side, because otherwise buttons tend to get bumped. I then do most of my usage through bluetooth VC (such as dialing, etc.) So, for my usage, it would be ideal if your app would work if run while the unit is locked. That way, when I'm going to be wearing by BT headset, I could just run the app via VC and then just before I take it off, I could run the app again without unlocking it. I have renamed the lnk to "Transfer Ring" and can just hit my BT switch and say "Start Transfer Ring". The app runs fine when I do this, but only if the 6700 is unlocked. If it's locked, then I run into the problem I've just described. Anyway to get the app to successfully exit the settings screen if the app is run while the unit is locked?

I've actually been away from my computer since I posted the fix, so sorry for the late reply. But I will look into this. I did not think about it may be ran while locked. I will address this issue first chance I get today.